Posts Tagged ‘Training’

Removing a old hull out of its mould and fiting out the restoration 8ft dinghy

October 8, 2017

Removing matting from the where the bow seat was to make the moulding flex enough to move out of the mould

Doing the same to the aft seat area and taking out wood in the keel area

Leveling up the dinghy in the cradle to ensure the seats get glassed in level

Glassing in the reinforcement plywood for aft seat

Trimming the bow seat moulding to fit the inside of the hull

Glassing in the transom pad to strengthen up the transom of the dinghy to take a reasonable size outboard motor should one be fitted by its new owner

Ensuring the dinghy stays level while glassing in  the bow and aft seats.

Advertisements

An Enterpise Dinghy in the Workshop for some TLC

March 5, 2017

An Enterprise in need of a good bit of restoration and a good drying out before it can get re-varnishing on the decks and inside before it can get refitted

The decks need a good rubbing down and re-varnishing

The port front spray rail needs to befitted and the deck fittings will be complete

Now that it is in the workshop and out of the weather then work can re-start on the Enterprise

Total cockpit overhaul needed on the yacht

February 28, 2017

The cabin bulkhead is in the worse condition and will need the most work on

The aft bulkhead is a lot smaller and should not be as larger job as the front, however, smaller areas can cause their problems

One of the first jobs is to remove all the equipment that is the way to gain access to the bulkheads and to the cockpit coamings that have to be removed to be able to remove the old rotten wood.

One side is already clear of obstructions

While the other side as yet to be started on

Side on view

A view looking forward a mess of wiring to be removed and labelled up

Refitting a rudder fitting using a traditional method of fixing the fitting to the rudder blade

February 26, 2017

Making traditional copper fixings to fit rudder fitting to rudder.

Fitting the first of copper fixings

Half of the fixing made and ready to fix to the rudder fitting

All of the fixing cliched up and rudder fitting fixed in position and now getting a coat of underwater primer before fixing the rudder back on the yacht

Making and shaping the outboard pad and reinforcement battens and centre keel reinforcement batten.

November 29, 2016

Making and shaping the internal after of the outboard pad

Making and shaping the bilge keel reinforcement wooden battens

Making and shaping the centre keel reinforcement and then holding them down into position

Little Mai in the workshop and now it is time to start to fit her out and then get her ready for the new season

November 28, 2016

Finally got the mould with the dinghy in the workshop ready to make a start on fitting her out

First dry fitting the stern seat before make the transom pad for the outboard and then glass in the seat

Dry fitting the bow seat, however before  the glass in this bow seat in, there is the  fitting of the bow eye bolt

Let the fun begin

Removing a rotten foredeck

November 13, 2016

Marking out the areas between the deck beams so not to cut them while removing the deck

More marking out

One major bit to remove from the fore deck,so to gain access to the two damaged deck beams below

Steel knee put in sometime in the past to connect the deck beams to the grown frames

This is the port side deck to hull steel knee before the deck is removed

Most of the foredeck is off now, just a small area beside the forehatch area to the cabin front left to remove.