Posts Tagged ‘tools’

Total cockpit overhaul needed on the yacht

February 28, 2017

The cabin bulkhead is in the worse condition and will need the most work on

The aft bulkhead is a lot smaller and should not be as larger job as the front, however, smaller areas can cause their problems

One of the first jobs is to remove all the equipment that is the way to gain access to the bulkheads and to the cockpit coamings that have to be removed to be able to remove the old rotten wood.

One side is already clear of obstructions

While the other side as yet to be started on

Side on view

A view looking forward a mess of wiring to be removed and labelled up

Refitting a rudder fitting using a traditional method of fixing the fitting to the rudder blade

February 26, 2017

Making traditional copper fixings to fit rudder fitting to rudder.

Fitting the first of copper fixings

Half of the fixing made and ready to fix to the rudder fitting

All of the fixing cliched up and rudder fitting fixed in position and now getting a coat of underwater primer before fixing the rudder back on the yacht

Making and shaping the outboard pad and reinforcement battens and centre keel reinforcement batten.

November 29, 2016

Making and shaping the internal after of the outboard pad

Making and shaping the bilge keel reinforcement wooden battens

Making and shaping the centre keel reinforcement and then holding them down into position

Little Mai in the workshop and now it is time to start to fit her out and then get her ready for the new season

November 28, 2016

Finally got the mould with the dinghy in the workshop ready to make a start on fitting her out

First dry fitting the stern seat before make the transom pad for the outboard and then glass in the seat

Dry fitting the bow seat, however before  the glass in this bow seat in, there is the  fitting of the bow eye bolt

Let the fun begin