Archive for the ‘Boat Tenders’ Category

Removing a old hull out of its mould and fiting out the restoration 8ft dinghy

October 8, 2017

Removing matting from the where the bow seat was to make the moulding flex enough to move out of the mould

Doing the same to the aft seat area and taking out wood in the keel area

Leveling up the dinghy in the cradle to ensure the seats get glassed in level

Glassing in the reinforcement plywood for aft seat

Trimming the bow seat moulding to fit the inside of the hull

Glassing in the transom pad to strengthen up the transom of the dinghy to take a reasonable size outboard motor should one be fitted by its new owner

Ensuring the dinghy stays level while glassing in  the bow and aft seats.

Advertisements

working on Yacht Norma Deadwood and restoring another 8ft dinghy

October 8, 2017

Marking out and cutting across the plank to make it easier to remove

The aft bolt still in postion and the copper nails still inposition as these have been nailed and roved in position so they can not be removed without cutting them out.

a close up of same area

Grinding back the area for the front seat to be glassed into position

The transom sanded down to make it flat and smooth.

A busy day in the workshop with boat movements and new projects underway

April 29, 2017

All change in the workshop, out with the Enterprise

in with a couple of small dinghies for work, one for repairs and the other dinghy to be fitted out

The outboard as been serviced and just need a new fuel line and the returned to its owner for him to use it for trawling along at slow speed

The Hardy Navigator table and cabin doors and hatch getting their final coats of varnish

The 8ft dinghy in its mould ready to be removed and fitted out

Another 8ft dinghy in for repairs to its transom where the wooden trim which as come off when it was last out sailing

The Enterprise is out in the yard while the small dinghies are being worked on before coming back in to be finished off

Another 8ft dinghy which as been brought in for a restoration by the company’s second apprentice under the watchful eye of the boss

A small dinghy repair so a client’s children can go sailing over the May Day holiday weekend

April 29, 2017

A small sailing dinghy brought in for a small wooden trim repair

the quarter knees and the transom trim fixings had failed due to old age

 

 

 

Clamping back into position and using a heavier grade of fixings and a better method of fixings so the problem does not happen again

 

All finished and ready to retuen to a happy client so he can go sailing over the bank holiday weekend

 

More work done the Little Mai dinghy over the Christmas break

December 31, 2016

All the glassing done inside the dinghy apart from the centre thwart seat blooks

   

Now ready to be flow coated

Flow coated and the stern seat in position ready to glass in position

The bow seat glass work now flow coated and ready for the inspection hatch to be fitted and the hardwood strips to be fitted on the top

Glassing in the keel backing pads

December 16, 2016

Starting to glass in the backing pads

The whole of the backing pads glass over with two layers of 2 oz CSM

looking forward to the bow seat / buoyancy tank all we have do now is glass in the stern seat / buoyancy tank. Then fit the centre seat blocks and then lift it out of the mould to fit the inwales and gunwales.